Place wood blocks in those holes or you can use concrete blocks. The entire process can be easy or tedious, depending on the home page
If you so choose to, you can allow your trampoline slope a little as well.
How to set up a trampoline on uneven ground. Stand on the downslope side of the trampoline, and place the carpenter's level on the plank. You can now use a stick to make sure the ground is now completely level. Just dig a hole based on the size of the trampoline you currently own, and in a few short steps (just follow this quick and easy tutorial from all things thrifty), you'll have one all set up for under $300.
Screw the butted ends to make a simple box.set the box in place on the ground. Use the carpenter's level to make sure the trench is level. You'll need a plank that's longer than the width of the trampoline to make sure it goes all the way across.
A trampoline that is on unlevel ground is unsafe, and a sky bouncer trampoline is no exception. You will need someone to help place the level between the stakes. This should even things out and create a safer bouncing surface.
If your only option is to set up the trampoline on uneven ground then make sure it will be safe. Your trampoline must not be laid out perfectly leveled. Raise the end of the plank until the carpenter's level shows that the plank is.
This task will be a bit tougher but the best practice is to install the trampoline on even ground where you can move them. Place your trampoline in the area you'd like it to be. Placing a trampoline on uneven ground can be tricky especially when keeping it safe.
You will need a helper to attach the string level to the middle of the string and then have you move the string up or down on one side until the bubble on the level is in between the lines. However, make sure the land is not uneven. In the event that your trampoline is uneven, the following can be used to remedy the situation.
The question arises actually for some reasons. One option is to shorten the legs and another option is to use boards or bricks to keep the legs sturdy. Setting up trampoline on concrete as we have already mentioned, it is a very bad idea to set your trampoline up directly over concrete because it is unsafe and will cause breakages in the frame.
Set the trampoline in the area in which you will use it. Set a plank across the middle of the trampoline, so that in runs straight up and down in the direction of the slope. Lift up the low ends until level and block it up.
This should be consistent all the way around the trampoline perimeter and the perimeter radius will be dependent on the overall size of your trampoline diameter. A few dips are fine, just so long as there isn’t an obvious and unavoidable slope. You can now use a stick to make sure the ground is now completely level.
Dig 4 squares, 1’ by 1’, making sure the depths are equal and level with each other. You will need to stay under the maximum weight capacity if you want your trampoline to last Make sure you have a good place to set a trampoline up before you buy one.
You will also want to use a tamper to compact the dirt and ensure that your trampoline won't just sink into the ground. If your garden is a little bumpy, it may still be possible to set up your trampoline safely. Ground:trampolines must sit on level ground, since placing a trampoline on an uneven surface may result in it tipping over.
You will want to then rotate the string several times to ensure that the entire area in which you want to place your trampoline is level. All you need do is dig in a little more on the high side and allow the trampoline frame to stick out above the ground at the lower end. Therefore, you'll need to purchase either trampoline rubber floor guards or trampoline rubber feet to protect the trampoline from the stress of use on concrete.
Do not jump on a trampoline that is unlevel, even if it is an enclosure trampoline. To do this, mark the stick as you move it different places along the line. Use a rake to complete the fine leveling of your area.
Using a trampoline in an unsuitable area can lead to injury and damage the trampoline. Can you set up a trampoline on grass? Now, find a stick and mark it as you move down the string.
Set the box right where you want it, allowing for pathway widths.add corner stakes and screw the bed sides to the stakes. When putting a trampoline in the ground, you need to leave enough room for the air to escape. Set the trampoline in the area in which you will use it.
If the grass in your garden is slightly uneven, apply some force to push the legs of the trampoline into the earth. Finally, move the string up or down until the bubble in the level is between the lines. Place a flat plank across the middle of the trampoline.
Move the trampoline back to its original position, with the uphill legs in the trench. Diy leveling your trampoline on uneven ground. Move the trampoline out of the way and dig a trench under the area where the uphill legs of the trampoline will be placed.
Whichever option you choose make sure the trampoline is safe. Using a trampoline on a hard surface such as concrete will. You will need a helper to attach the string level to the middle of the string and then have you move the string up or down on one side until the bubble on the level is in between the lines.
Set a plank across the middle of the trampoline, so that in runs straight up and down in the direction of the slope. Place your swing set on the blocks. The depth of this trench should equal the total amount of slope you measured.
It is even the most convenient way to install a trampoline. We hope by now, how to prepare the ground for a trampoline isn’t an issue for you anymore. Use a level to make sure the blocks are equal and level.
To use it, place two stakes in the ground around the area you plan to level then run a string between them. Before installing the in ground trampoline, you will have to take the time to level the area the trampoline will sit on.